In my attempts to speed up the Tip It guide in making Primed bars from Elemental Workshop and future ones (maybe there will be a fourth EW), I have found some ways to slightly speed the process up. All the steps inlaid in the guide except the initial heating of the bar can be sped up a little bit to up to minute or more sooner.

 

1. After you hit the press lever, you don't need to okay the message
   
2. When the jig is in the coolant tank and the door is closed, open the fill valve and get the message its open, then close it
   
3. Do the same for the drain valve, then extract the bar
   
4. The blower lever can be used twice immediately to dry the bar; no need to wait for messages
   

 

I thought this might speed the process of making many primed bars, as it is a bit more cumbersome with the provided instructions.

In my opinion, additional text for these little things would make the guide even longer, which wouldn't be something I'd aim for. I just recently added simplified instructions to the EW III guide, instead of refering to EW II. Maybe this will help with that. I'll look into cutting down some of the text in the EW II guide, instead.

 

Thanks for your submission, however! :)

 

DK