elemental workshop 3

[pulli23]

Hello,

 

I'm working on the lever puzzle for elemental workshop 3.. However I can't seem to fix it..

 

 

I do understand how it works, however in some way the "top layer" (TALL and MED size tiles) won't move from that position...

 

Even if I follow the tip it guide (first "2" then "A" to quickly remove the TALL tile) it will only move upto that tile (not including the top tile.. Also a strange thing happens, in my screen the top level is slightly raised....

Am I missing a part?

[Flyingjj]

Yes, you are missing a part. The tip.it guide is confusing in that you cannot get infinite moves until you do Puzzle part 1 and puzzle part two. These will unlock the medium and tall size tiles, respectively, and you need the tall one to get infinite moves. In my opinion, the infinite moves solution is placed at the wrong point in the guide and confused the heck out of me until I figured this bit out.

[Sy_Accursed]

Yeah tip.it guide is slightly misleading.

 

At the start the two corners and thus the mid and tall pieces are up in the air, First puzzle part lowers the right and thus the mid piece, 2nd bit uses mid piece to lower the left and thus the tall piece.

 

It is only after this that you can activate the infinite moves counter.

[shamsa]

i have kind of a problem with elemental workshop 3.. i accedently resetted the puzzle after i made the first bar..

though i puzzled for hours to try figure out how to go on.. i just dont see it.. can someone give a hint please?

[Sy_Accursed]

To make a bar you have to lower the centre, charge it and raise it again.

 

So simply do thoose steps in the tip.it guide

[pulli23]

well figured out doing it myself was easier than following those steps (often messed up where I was in the sequence, since it had often repetitions).

[shamsa]

yay finaly finnished thx ppl for the hints.. i am not a smart puzzler.. lol

[Saneug]

Well, I have done Elemental workshop 1 and 2 and never had a problem. Now in 2 I can't even finish the prime bar. When I go to pick the bar off the cart all completed, it says: "You should finish the process before taking the bar." What in the world am I doing wrong. I have worked on this for over an hour now. When I did Elemental workshop 2, I had to repair everything, do I have to do that again in 3??

 

 

Okay, never mind. I figured it out. There was a cog missing. I must have messed that part up some how. Glad I could air it out on here anyway, it helped.